Software Update Name: BCM450.R600.FPGA-78

Applicable H/W Platforms: BCM450

Applicable S/W Platforms: 10.0

Category: LTD

Installation Recommendations:
This update should be applied to BCM450 Release 6.0 installations which is
going for an external soft reset or Hardware Watchdog reset.

CAUTION:
Installing new FPGA firmware on a BCM is comparable to upgrading the
BIOS on a Windows PC. When this patch is applied the BCM should not be
interrupted or power cycled. If disturbed the FPGA may get corrupted and
the BCM may render non-recoverable.

It is strongly recommended that one  connect the BCM 450 system to a UPS power
backup to ensure that there are no power interruptions during the upgrade
process.

There must be no call activity during patch installation.

It is advisable to have a standby BCM in case the system would fail for
unforeseen reasons.

The power LEDs may change from solid green to blinking yellow under high SPI
stress. This is an expected behavior and does not have any operational
impacts.

It is advisable to apply the latest kernel patch before applying this patch.

During the fpga installation both power and status  LEDS will be turned  off.
This is normal operation when installing an fpga patch.

The BCM will reboot if the patch installs successfully. If for some unforeseen
reason the patch fails  to install the BCM will NOT reboot.  if the patch
fails to install DO NOT REBOOT THE BCM. Contact Avaya support  for assistance.

It is possible that the Element Manager(EM) might hang during this installation.
If this scenario is experienced, please kill the EM using task manager and re-open
the EM. If BCM is getting connected after 7 minutes from the time of applying the 
patch, collect the logs from BCM and send it Avaya for investigation. Please note
if the EM get connected without any error message then the patch is applied 
successfully.

Components and Versions:

   fpga 6.1.5.10

Dependencies: None

Product Dependencies: None

Size: 0.10 MB

System Impact:
Time to apply approximately 10 minutes

Does update application force reboot: Yes

Other Impacts: None.

Limitations: None

Update Removable: No

Description:
-----------
The following issue is addressed:

1. System rebooted on its own.
   System resets on its own and reboot reason is "Hardware Watchdog" or
   "External Soft Reset". This fix makes the SPI interface and watchdog
   implementation in  hardware monitoring FPGA more robust by taking care of
   glitches which may corrupt the FPGA registers.
   wi01029594,wi01031351

This patch includes the content of the following superseded updates:
None



