CallPilot 1.07 PreCheck utility May 13/2004
-------------------------------------------

CallPilot systems are assumed to be installed in a particular way.  CallPilot is
not just a software application that can be installed on any Windows PC.  Instead, 
CallPilot is an integrated messaging solution consisting of multiple hardware
and software components.  Correct operation of a CallPilot system requires that
it be installed according to Nortel Networks published instructions and that the
system not be modified except according to Nortel Networks published procedures.

Non-standard configurations and unauthorized modifications of a CallPilot 1.07 
system can cause problems when installing new PEPs on that system or when attempting
to upgrade to later releases.

The CallPilot 1.07 PreCheck utility performs a number of system checks to determine
whether the system conforms with the expected, standard configuration.  Except for
writing a log file, the PreCheck utility does not modify or attempt to repair the 
system.  The PreCheck does not take the system out of service.  It is safe to run
it on a running 1.07 system.

The PreCheck identifies items that do not conform with the standard configuration.
Such items are described in dialog boxes and are logged to a log file.  PreCheck
failures should normally be fixed, then the PreCheck should be run again.

PreCheck should be run on a CallPilot 1.07 system prior to attempting to upgrade to 
CallPilot 2.02 or CallPilot 2.5.  Note that PreCheck failures do not prevent an
upgrade from being attempted.  However, such an upgrade is more likely to succeed
if there are no PreCheck failures.

You can run the PreCheck by executing "PreCheck.exe" by double-clicking in Windows
Explorer or by using "Start" - "Run".  It will self-extract to a folder under
D:\TEMP and will begin checking automatically.  Please read and follow any 
instructions that appear on the screen.  In particular, you will be guided to 
verify the list of installed software and the disk partitioning.

A log file is produced in the root folder of the system drive (where Windows NT
is installed) called "precheck.log".  Everytime PreCheck is run, it appends its
results to the end of the log file.  This file can be viewed using Notepad.  It
shows the checks that passed as well as any that failed.

Note that PreCheck cannot check every aspect of a CallPilot system.  Even if the
PreCheck does not find any problems, there could still be issues that might
interfere with a future operation.  If you notice something important wrong with 
the system, you should probably to resolve it, even if the PreCheck does not
complain about it.
